October 25, Messages: When I plug IR into the other Colossus, it is completely dead. As I wrote in my OP, I replaced both ir. To clear this message, click the red X in the upper left corner. That works on RPi anyway. I can’t find the ir receiver. Originally Posted by SHS.

Uploader: Daigul
Date Added: 12 February 2015
File Size: 65.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72422
Price: Free* [*Free Regsitration Required]

I am currently running Win updates no the second machine and we’ll see what happens.

I don’t know if this bit from lirc. Discussion in ‘ Remotes ‘ started by PaoloROctober 14, Could please someone advise on how to capture what is the machine getting from the remote, or how to log the whole communication? Interestingly enough I tried that before.

Originally Posted by Tiki The Hauppauge ir receiver uses a program called ir. So there is a difference between the Colossuses Colossi? Thanks for the new build. JulioQc November 20, We give away MediaPortal for free but hosting and software is not for us.


Hauppauge PCI-e Tuner with IR Receiver ?

How do I troubleshoot a favorite not recording? Hauppage remote stopped working after I update today Well, I ran Win10 updates today, rebooted and my Hauppauge IR remote does not work any more. PaoloROctober 27, I have two Colossus cards. Support d’installation et de configuration.

I would first check to make sure that is running. November 2, 7.

November 2, 6. Originally Posted by fbures. You should also be able to remove “IR. Care to support our work with a few bucks? DaGrizzlyOctober 24, Other keys are either huappauge or cause an escape from this screen. Last edited by SHS; at Just to add to my previous post: I did check if the firmware was available on the default 7.

The TV card is recognized, the ir receiver is not. I owe you a beer or two Thanks again Frank.

Hauppauge Webstore | edia Center remote control kit with USB based IR receiver/blaster

The eeprom on the TV card is reporting that there is a ir receiver attached to it because it was programmed with that information. About The Project The vision of the MediaPortal project is to create a free open source media centre application, which supports all advanced media centre functions, and is accessible to all Windows users.


This means that you should pay attention that your TV card is detected correctly by bttv, geceiver can be checked using dmesg 1. I think ” systemctl start lircd” is the command, or something like that.

IR-Receiver for Hauppauge Remote, 5,99 € – Hauppauge

This setup worked for many years. October 14, Messages: Also there is conflicting information about the IR receiver on the HVR-xxx5 cards, some sites indicate as if there is no driver available for these newer recriver. If you would like to use all features of this site, it is mandatory to enable JavaScript.